Just a reminder guys to take a few minutes and check that flex shaft. This may seem like a obvious tip but sometimes we forget that what's right under our noses. Take just a couple of seconds and verify everything is in order. After all, you don't want a break down. Preventative maintenance pays off BIG TIME!!

I'm so glad I went ahead and invested in the Accessory Bit Set. I've used a couple of the ogees to do some edge routing and used the v-groove one to make a bunch of signs. But my all time favorite is the 3/8 jointing bit. I use it all the time to square up the ends of my work pieces. I'd be lost without these guys!!!

CarveWright CW0024 Full Carving Bit Set